Denso RC5 Spécifications télécharger pdf (Page 75)

 Reset

This command immediately stops and also initializes the program of the

program number specified in data area 2. PRO0 to PR032767 can be

stopped.

This command cannot be used together with the program start

command.

To start a step-stopped or cycle-stopped program from the beginning,

use the program reset start command.

If the program number specified in data area 2 is negative, all programs

being executed will be reset.

One of the following operations takes place according to the operating

status of the program.

⋅ When the specified program is terminated (stopped), nothing will

happen.

⋅ When the specified program is step-stopped or immediately stopped,

it will be initialized. The initialized program will resume from the

beginning.

⋅ When the specified program is running, it will immediately stop and

also be initialized. If started after an instantaneous stop, the stopped

program will resume from the beginning.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 181 182

Pas de commentaire

Denso RC5 Spécifications Page 75