Denso RC5 Spécifications télécharger pdf (Page 60)

3.4.2 Robot Stop (Input)

(1) Function

 The signal stops the robot from the external device by opening the robot

stop input.

 The signal readies the power to the robot motor to be turned ON by

shorting the robot stop input.

(2) Terminal number

No.2 of connector CN8.

(3) Input conditions and operation

 The robot stops with this input OFF (open).

 The power to the robot motor is made ready to be turned ON with this

input ON (shorted).

 Irrespective of whether internal mode, operation by the teach pendant, or

external mode, remote operation by the external device, is selected, the

power to the robot motor cannot be turned ON with this input OFF (open)

and neither manual nor automatic operation can be performed until this

input is turned ON (shorted). (ERROR2008 will be displayed.)

 By turning OFF (open) this input the following conditions may result.

1) The power to the motor will be turned OFF irrespective of whether

manual, automatic, internal or external mode is selected.

2) During execution of the program (Robot-in-operation signal ON), the

power to the motor will be turned OFF and the mode will be switched

to internal mode after the robot decelerates to a stop;

3) When the program is not executed in manual and auto modes in

manual and auto modes, everything will be the same except the

power to the motor will be turned OFF. The power to the motor can be

turned ON and the suspended operation can, therefore, be resumed

by shorting the ROBOT STOP input. (However, the program will be

executed from the beginning.)

 Opening the ROBOT STOP input and pressing the ROBOT STOP

button of the operating panel or the teach pendant function is the same.

(4) Timing of the input

This input will be processed prior to all commands and input signals.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 181 182

Pas de commentaire

Denso RC5 Spécifications Page 60