Denso Power Net Terminal BHT-103 Manuel d'utilisateur télécharger pdf (Page 145)

129

Barcode Handy Terminal

6.2 Replacing the Back-up Battery

If the following warning message displays, contact your dealer and replace the back-up battery.

This warning message displays each time the power is turned ON after the back-up battery discharge count has

reached 200 times or more.

Even if this warning message displays, operation can be resumed by tapping the OK button in the top right corner of

the message window.

− Point −  If the back-up battery is removed, it may not be possible to back up the content of the RAM, and

data including files and settings stored in the RAM may be lost. In that case, because the RAM will

revert to the factory default, it is recommended that any important data be backed up to the

“FLASH” folder or uploaded to the host computer. When the BHT turns ON after the data in the

RAM is deleted, the BHT starts from the “Initial Setup”.

 Each time the back-up battery is fully discharged, the discharge count automatically increases by

one, however, replacing the back-up battery does not reset this value to zero automatically. As a

result, it is necessary to reset the discharge count in accordance with the procedure described in

“Chapter 4 System Operation” – “4.4.3 System Properties” – “[10] Resetting the Back-up Battery

Discharge Count” when the back-up battery is replaced.

Please note that the back-up battery discharge count is reset when the BHT is shipped from the

factory.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 175 176

Pas de commentaire

Denso Power Net Terminal BHT-103 Manuel d'utilisateur Page 145