Denso BHT-825QW Manuel d'utilisateur télécharger pdf (Page 137)

122

BHT-825Q series

[2] Memory test

Use the following procedure to perform a memory test.

1. Select “2: MEMORY” at the TEST menu and then press the ENT

key.

The screen on the right displays, and the BHT reads and writes data to and

from all areas of the RAM and performs an address check.

“XXXXX”: Tested RAM capacity (unit: kilobytes)

“YYYYY”: Total RAM capacity (unit: kilobytes)

If any error is detected, the BHT speaker beeps three times, displays a

message similar to that shown on the right, and aborts the memory test.

“ZZZZZZZZ”: Address where the error occurred

“AAAAAAAA”: Data to write

“BBBBBBBB”: Data read out the RAM

Press the BS/C key to return to the TEST menu.

Upon normal completion of the RAM test, the BHT speaker beeps once,

displays a message similar to that shown on the right, and returns to the

TEST menu.

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 252 253

Pas de commentaire

Denso BHT-825QW Manuel d'utilisateur Page 137