Denso BHT-200QW Spécifications télécharger pdf (Page 19)

- 17 -

▪ ENCRYPTION

This is the encryption method setting. A selection can be made from Prohibited, WEP, and TKIP.

▪ AUTHENTICATION

This is the authentication method setting. A selection can be made from Open, Shared, and WPA for units

running on Windows CE 4.2, and a selection can be made from Open, Shared, WPA, and WPA-PSK for

units running Windows CE 5.0.

▪ EAP TYPE

This is the EAP type setting. A selection can be made from Prohibited, PEAP, and TLS.

▪ WEP KEY

The encryption key (WEP KEY) can be set.

▪ Pre Shared KEY

Used to specify the PreShared key. (Only on units running on Windows CE 5.0.)

[Ex.] Settings required to connect to a network using PEAP(802.1x)

MyProfile.Authentication = RF.Profile.EN_AUTHENTICATION.OPEN

MyProfile.Encryption = RF.Profile.EN_ENCRYPTION.WEP

MyProfile.EAP8021x = RF.Profile.EN_EAP8021X.PEAP

[Ex.] Settings used to enable WEP. Sets the WEP KEY to

"01234567890123456789ABCDEF" (128-bit).

MyProfile.Authentication = RF.Profile.EN_AUTHENTICATION.OPEN

MyProfile.Encryption = RF.Profile.EN_ENCRYPTION.WEP

MyProfile.EAP8021x = RF.Profile.EN_EAP8021X.DISABLE

MyProfile.WepKey = “01234567890123456789ABCDEF”

5.2.2. Parameter Setting in NIC Control Mode

Make the following system setting values at either the System Menu or in a user program in order to establish

the wireless communication pathway.

▪ POWER

▪ ESSID (Extended Service Set ID)

▪ AUTHENTICATION

▪ WEP KEY

For the setting procedure at the System Menu, plese refer to the "BHT-200B/200BW-CE User's Manual" or

“BHT-200Q/200QW-CE User's Manual".

If no system settings are made in a user program, those made at the System Menu will apply.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 376 377

Pas de commentaire

Denso BHT-200QW Spécifications Page 19